Page 8 of 10

  • Outside Agencies – The applicant should indicate the current status of the following outside agency approvals/permits which will be required in conjunction with any approval the Board may grant:
  • Ocean County Planning Board
  • Ocean County Board of Health
  • Ocean County Soil Conservation District
  • Jackson Township MUA
  • Jackson Township Bureau of Fire Prevention
  • Jackson Township Environmental Commission
  • Jackson Township Forrester

D. Technical Revisions and/or Corrections

  1. Additional pavement markings and traffic control devices should be added to ensure design circulation patterns are properly established.
  2. A general note should be added indicating that all site lighting will be adjusted as may be directed by the Township/Inspecting Engineer should unanticipated offsite lighting impacts result from the development which is proposed.
  3. A general note should be added indicating that additional landscape plantings will be provided as may be directed by the inspecting engineer should the preservation of existing vegetation be inadequate to provide proper screening. Daffodil bulb planting should be added to the landscaping seed mix.
  4. The Grading Plan should be revised to provide additional spot grades so as to ensure design grading patterns are properly established.
  5. Curbing radii for all internal curbing shall be indicated at 5.0 FT minimum radius and internal islands at a 10 FT minimum width.
  6. The solid waste storage area should be reviewed for compliance with Ordinance 244-208.
  7. Plan revisions required to address the specific provisions of Chapter 364, if applicable.
  8. Light pole footings should be indicated with a 6.0" maximum exposure.
  9. Dimensions shown for "Porous Pavement" Areas 2A and 2B should be verified.
  10. A detail: "Basin Access Drive- Permeable Grass Paver Surface Detail" is provided on Sheet 15. The access drive should be labeled on Sheets 4 and 5 for Surface Basin 1 and Surface Basin 3.
  11. Chain link fences should be provided around both Surface Basins along with a gate allowing a pathway to the access drives.
  12. Guide rails are proposed adjacent to Surface Basin 1 and Surface Basin 3 and are labeled on Sheet 3. Labels for the guide rails should be added to Sheets 4 and 5.
  13. The proposed retaining wall should be labeled on Sheet 3.