- iv.Typical edge of slab details for cladding attachment
- v.Special construction conditions noted (if needed)
- vi.Provide wind, seismic, dead and live loads design information
- vii.Provide accommodation for seasonal systems design - information as necessary to define construction
- viii.Footing, beam, column and connection details
- ix.Building elevations for architectural precast construction
E. MECHANICAL:
a. Floor plans
- i.Size and locate utility risers, shafts, chases and equipment coordinated with architectural plans
- ii.Heating and cooling load criteria for each space and major duct or pipe runs sized to interface with structural and architectural building components
- iii.Mechanical room equipment layouts
- iv.Locate major equipment such as air handling units, heat pumps, exhaust fans, unit heaters, etc.
- v.Locate intake and exhaust louvers
- vi.Locate and indicate air curtains and/or seasonal systems
- vii.Indicate typical layouts of all ceiling devices
- viii.Consider access and replacement requirements with all equipment room layouts
- ix.Coordinate ceiling plenum space with architectural, plumbing, fire protection, electrical and structural
- x.Air and water flow diagrams showing CFM and GPM respectively
- xi.Show electrical requirements such as panel size, location, voltage and current requirements or mechanical equipment
F. PLUMBING/FIRE PROTECTION:
b. Sections:
c. Catalog Cuts:
- i.Critical mechanical room cross sections
- ii.Corridor sections including duct clearances
- i.Grilles and diffusers
- ii.Special equipment
- iii.Controls/Building Management Control System (BMCS)
- a.Floor plans:
- b.Detail plans:
- 8
- i.Size and location of utility risers, shafts, chases and equipment
- i.Locate all toilets, urinals, lavatories, mop sinks, floor drains and drinking fountains